Aquatec Ocean Mode D'emploi page 10

Shower and Toilet Commode Ocean / Ocean XL
6. Remove the backrest bracket
upwards.
The smaller hole serves to fix the retaining clamp.
i
7. Insert the screws in the armrest bracket and guide them through
the holes in the backrest frame.
8. If required, put the nuts back into the retaining clamp.
9. Place the retaining clamp on the backrest frame so that the fixing on
the retaining clamp projects into the smaller hole.
10. Turn the screws in the nuts and tighten.
11. Pass the belt of the backrest cover that is still open on the outside
of the backrest frame, close and tighten all belts.
IMPORTANT
The armrests are lowered using the same procedure.
▸ When converting to the lower position, the belt that lies
beneath the armrest must be opened and passed inside the
backrest frame.
10
with the armrest and move it
A
Fitting footrests
IMPORTANT
▸ The assembly is the same for the right and left footrest.
1. Push the footrest with the footplate
B
front of the side part until the groove
I
the clip G. The footrest can no longer be turned to the side.
Adjusting the height of the footrests
1. Pull the footrest up a little.
B
2. Pull out the clip and push it back in in the desired position. If
G
required, pull out the footrest a little further to do this.
3. Push the footrest downwards until the groove
pin of the clip.
4. Set the second footrest to the desired height as described.
Assembly and installation
into the guide at the
D H
engages with the pin of
A
engages with the
A