HENX H36GC20 Mode D'emploi page 29

There is • The cutting blade is loose.
excessive
• The cutting blade is
vibration
• The cutting blade is bent.
• The motor shaft is bent.
The handle- • The side rails are not fully
locking clamps
cannot be
closed in
position
Mower is • The wheels are temporarily
difficult to pull
back when the
self propel is
turned off.
The motor • The blade is not tightened to the
works but the
blade doesn't
cut the grass
Short running • Grass conditions and cutting
time of the
mower with
included
battery
unbalanced.
extended.
locked.
required torque.
height setting will greatly affect
the battery run time. The
claimed run time is based on a
light load condition.
• Tighten the blade bolt
• Balance the blade following the
instructions.
• Replace the blade.
• Contact the service center.
• Fully extend the side rails, then
lock the clamps.
• Simply push ahead slightly and
then move the mower as
desired.
• Re-tighten the blade. The
recommended torque for the
blade
bolt is 36-43 ft-lb (49- 59Nm)
• Raise the blade height and
slow your pace to reduce the
cutting load
English
29