Maintenance - HENX H36GC20 Mode D'emploi

approximately one third of the grass
blade length, ideally no more than 1 1/2"
at one time. If the grass is overgrown, it
may be necessary to increase the cut
height to make it easier to mow and to
prevent overloading the motor. Slow your
cutting pace in tall or thick grass
conditions. For mulching extremely thick
or tall grass, it is advisable to first cut at
a high cut-height setting, and then re-cut
to the final cut height. Otherwise, make
narrower cuts and mow slowly.
ALWAYS MAKE SURE THAT THE BLADE IS
SHARP.

12. Maintenance

WARNING: To avoid serious personal injury,
always remove the battery pack from the
mower before cleaning or performing any
maintenance.
WARNING: When servicing,use only
identical replacement parts. Use of any
other parts may create a hazard or cause
product damage. To ensure safety and
reliability, all repairs should be performed by
a qualified service technician.
Cleaning the mower
12.1
WARNING: Always remove the battery pack
when servicing or transporting the mower.
The underside of mower deck should be
cleaned after each use, as grass clippings,
leaves, dirt and other debris will
accumulate. This accumulation is
undesirable, as it will promote rust and
corrosion.
Removing the blade
12.2
WARNING: Always protect your hands by
wearing heavy gloves or wrapping the
cutting edges with rags or other materials
when performing any maintenance on the
mower blade. Always remove the battery
pack when servicing or transporting the
mower.
NOTICE: The following tools are required for
replacing the blade:
• 16mm wrench
• Torque wrench
• Manual screwdriver or metal rod with a
diameter of 5/16" (8mm)
a. Stop the motor; remove the battery
pack from the mower.
b. Turn the mower on its side.
c. While wearing protective gloves, place a
metal rod(e.g.,a 3.5" length screw bit)
with diameter less than 5/16" (8mm)
into the fixing hole to act as a stabilizer
(See Fig. W).
d. Use a inch (16mm) wrench to turn the
blade bolt counter clockwise to loosen
it.
e. Continue using the inch(16mm) wrench
to turn the blade bolt counter clockwise
to loosen it completely.
f. While wearing protective gloves,
remove the bolt, outer flange and the
blade (See Fig. W).
Installing the blade
12.3
Gloves or wrapping the cutting edges with
rags or other materials when performing
any maintenance on the mower blade.
Always remove the battery pack when
servicing or transporting the mower.
NOTICE: To re-install or replace the blade,
be sure to replace the parts in the exact
order in which they were removed
(See Fig. X).
a. Mount the inner flange to the fan
(See Fig. Y).
b. Mount the fan and the inner flange onto
the motor shaft with the fan blade
towards the deck (See Fig. Z).
c. While wearing protective gloves,
position the blade on the inner flange
with the surface stating "THIS SIDE
FACING GRASS" facing toward the
outside (See Fig. V).
d. Determine the direction of blade
according to the position of mounting
holes.
e. Mount the bolt into the shaft and turn it
clockwise by hand to pre-tighten it.
f. While still wearing protective gloves,
hold the blade with one hand and turn
the fan with the other hand to align the
holes in the blade with the through
holes in the inner flange (See Fig. AA).
g. Place a metal rod (e.g., a 3.5" length
screw bit) with diameter less than 1/4
English
25