HENX H36GC20 Mode D'emploi page 22

English
Upper operating position
Press and hold the quickadjustment lever
with your left hand to release the handle
from Grass Bag Attachment/Removal
Position (See Fig. G).Begin to lower the
handle with your right hand, and then
release the lever. Gently pivot the handle
downward until you hear and feel the lock
pin engage in the Operating Position (See
Fig. G). Fully extend the side rails and
securely close the two handle-locking
clamps (See Fig. H & I).
NOTE: The motor cannot be started unless:
• The side rails are fully extended
• Both green handle-locking clamps are
securely closed
• The handle is locked into Operating
Position.
Attaching/Removing the grass bag
10.2
WARNING: Do not at any time make any
adjustment to the lawn mower without first
stopping the motor,removing the battery
pack and waiting for the blade to stop
rotating.
NOTICE: Remove the mulching insert or
side discharge chute before attaching the
grass bag on the mower;
a. Remove the battery.
b. Adjust the handle to the Grass Bag
Attachment/Removal Position (please
see "Adjusting the foldable handle").
c. Lift the rear-discharge door.
d. Hook the grass bag assembly on the
pivot rod (See Fig. J). Release the
discharge door so that it rests on the
grass bag.
e. To remove the grass bag, lift the rear-
discharge door on the mower. Lift the
grass bag up, off of the pivot rod.
f. Release the discharge door.
WARNING: When using the grass bag, never
operate the mower unless the hooks on the
grass bag are firmly seated on the pivot rod
and the rear-discharge door rests firmly
against the top of the grass bag.
WARNING: Under normal usage, bag
material is subject to wear. To reduce the
risk of injury, frequently inspect the bag
assembly and replace if there are any signs
22
of wear or deterioration. Use only grass
bags manufactured for this mower.
Attaching/Removing the mulching
10.3
insert
WARNING: Do not at any time make any
adjustment to the lawn mower without first
stopping the motor, removing the battery
pack and waiting for the blade to stop
rotating.
a. Remove the battery.
b. Lift the rear-discharge door.
c. Grasp the handle of the mulching insert
and fully insert it into the mower, so that
it is securely seated(See Fig. K).
d. To remove the mulching insert, lift the
rear-discharge door, grasp the handle of
the mulching insert,and pull it out.
e. Release the discharge door and make
sure it rests firmly against the mulching
insert.
NOTICE: The mulching insert must be
removed in order to install and use the
grass bag and must be re-installed when
the grass bag is removed.
Attaching/Removing the side
10.4
discharge chure
(Available separately) (See Fig. L & M)
WARNING: Do not at any time make any
adjustment to the lawn mower without first
stopping the motor, removing the battery
pack and waiting for the blade to stop
rotating.
a. Remove the battery.
b. Lift the rear-discharge door.
c. Align the lower edge of the discharge
with the groove of the door sill and
insert it into the slot.
d. Push the top of the discharge and insert
it into the mower. Check to see that it is
securely seated in the deck.
e. To remove the side discharge chute, lift
the rear-discharge door,grasp the side
discharge chute and pull it out.
f. Release the discharge door and make
sure that it rests firmly against the
discharge chute.