HENX H36GC20 Mode D'emploi page 27

a. Move the cutting-height adjustment
lever toward the front and engage it in
the lowest setting (setting 1).
b. Open the handle-locking clamps and
fully recess the side rails to the
compact position.
c. Press and hold the quick-adjust lever
with your right hand to release the
handle.
d. Gently pivot the handle toward the front
of the mower; release the quick-adjust
lever and continue to pivot the handle
until you hear and feel the lock pin
engage in the locked storage position.
• Place the folded mower upright on the
ground (See Fig. AG).
• Lubricate the deck-height adjustment
joint.
• For H36GC20, lubricate the bearings in
both the rear and front wheels
(See Fig. AG).
Replacing the wheels (See Fig. AH & AI)
12.8
WARNING: Always remove the battery pack
when servicing or transporting the mower.
a. Turn the mower over on its side and
lean the upper surface against the wall
b. Use a flat-edged screwdriver to pry the
dust cover off the wheels.
c. Use an adjustable or 1/2 inch (13 mm)
wrench to turn the bolt counter
clockwise to loosen it.
d. Remove bolts and worn wheels from
axle
e. Install the new wheels on the axle and
tighten the wheels clockwise with bolts.
f. Install the dust cover on the wheel and
press it into position.
Storing the mower
12.9
The following steps should be taken in order
to prepare the lawn mower for storage.
a. Remove the battery pack from the
mower and store it at room temperature
in a dry location.
b. Clean the mower as described earlier in
the maintenance section.
c. Inspect the blade and replace it or
sharpen it if required.
d. Lubricate the mower.
e. Store the mower in a dry,clean location.
Do not store it next to corrosive
materials, such as fertilizer or rock salt.
f. Store the mower in a covered, enclosed
space, that is cool and dry and out of
the reach of children.
g. Do not cover the lawn mower with a
solid plastic sheet. Plastic covering
strap moisture around the mower,
which causes rust and corrosion.
The handle assembly can be folded away
completely for storage
1. Remove the grass bag.
2. Move the cutting-height adjustment lever
toward the front and engage it in the lowest
setting (setting 1).
3. Open the handle-locking clamps and fully
recess the side rails to the compact
position.
4. Press and hold the quick-adjust lever with
your right hand to release the handle. Gently
pivot the handle toward the front of the
mower; release the quick-adjust lever and
continue to pivot the handle until you hear
and feel the lock pin engage in the locked
storage position.
5. Store the mower flat or upright
(See Fig. AJ & See Fig. AK).
WARNING: If the mower to tips over from
the upright position, mower damage or
personal injury may result. Always keep the
mower stable and out of the reach of
children when it is in the upright position. If
possible, lay it flat for storage.
English
27