Important Safety Instructions - HENX H36GC20 Mode D'emploi

English
and understand operator's manual
before using this product.
Eye Protection. Always
wear safety goggles or
safety glasses with side
shields and a full face
shield when operating
this product.
Keep Bystanders. Away keep
all bystanders at least 50 ft.
away. Never operate the
machine while people,
especially children, or pets
are nearby.
DANGER — Steep Slope
Hazard. Use extra caution
on slopes. Do not mow
slopes greater than 15
degrees.
Remove disabling device
before maintenance.
CE stands for "Conformité
Européenne", which means "In
accordance with EU Regulations".
With the CE marking, the
manufacturer confirms that this
Electric tool complies with the
applicable European directives.
This product uses lithium-ion
(Li-ion) batteries.Local,state,or
federal laws may prohibit disposal
14
Maintain Safety
Devices. Do not open
or remove safety
shields while the tool
is running.
Look down and
behind first to avoid
tripping when pulling
back.
of batteries in ordinary trash.
Consult your local waste authority
for information regarding available
recycling and/or disposal options.
Charging and Store the battery
pack only in dry rooms with an
ambient temperature of 50°F to
104°F (+10°C to +40°C).
Ingress
IPX1
Protection
IPX4
Degree
V Volt
A Amperes
Hz Hertz
W Watt
min Minutes
Alternating
current
Direct
current
No load
N
speed
0
... /min Per minute
WARNING: To ensure safety and reliability,
all repairs should be performed by a
qualified service technician!

3. Important safety instructions

DANGER: This machine was built to be
operated according to the rules for safe
operation included in this manual. As with
any type of power equipment, carelessness
or error on the part of the operator can
result in serious injury. This machine is
capable of amputating hands and feet and
throwing objects. Failure to observe all
safety instructions could result in serious
injury or death.
Protection from
splashing water
Voltage
Current
Frequency
(cycles per
second)
Power
Time
Type of current
Type or a
characteristic of
current
Rotational speed,
at no load
Revolutions,
strokes, surface
speed, orbits etc.,
per minute