Olimpia splendid UNICO EASY S1 Mode D'emploi page 40

10. During assembly and at each maintenance operation, it is necessary to
respect the precautions indicated in this manual and on the labels located
inside or on the appliance, as well as to take all the precautions suggested
by common sense and by the Safety Regulations in force in the country of
installation.
11. In case of replacement of parts, use only original OLIMPIA SPLENDID parts.
12. If the unit is unused for a long period, or no-one uses the climate-controlled
room, it is recommended to disconnect the electric power supply in order
to prevent accidents.
13. Do not use liquid or corrosive detergents to clean the unit, do not spray
water or other liquids onto the unit, since they could damage the plastic
components or even cause electric shocks.
14. Do not wet the indoor unit and the remote control.
Short circuits or fires may occur.
15. In case of functioning anomalies (for example: abnormal noise, bad smell,
smoke, abnormal increase in temperature, electrical dispersions, etc.),
immediately switch off the appliance and disconnect the plug from the
power socket.
For repair work contact solely the technical service centres authorised by
the manufacturer and ask for original spare parts to be used. Failure to do
this can affect the safety of the appliance.
16. Do not let the air conditioner run for a long time when the humidity is very
high and a door or a windows is left open.
Moisture may condense and wet or damage furniture.
17. Do not disconnect the power plug during functioning.
Fire or electrical shocks hazard.
18. Do not place heavy or hot objects on top of the appliance.
19. before electrically connecting the appliance, make sure the plate data
correspond to those of the distribution network. The power socket must
be equipped with a Ground System. The plate is located on one side of the
appliance.
20. Install the appliance according to the manufacturer's instructions. An
incorrect installation can cause damage to people, animals or property for
which the manufacturer accepts no responsibility.
21. If the appliance's plug is incompatible with the socket, have the socket
replaced with a suitable one by a qualified technician, who must ascertain
that the section of the socket cables is compatible with the power absorbed
by the appliance. We do not recommend using adaptors and/or extension
cables. If they cannot be avoided, however, they must comply with current
safety regulations and their ampacity (A) must not be below the maximum
ampacity of the appliance.
EN - 6