C-Follow Me Function; D-Setting The Unit Of Measurement Of Temperature; E-Directing The Air Flow; F -Short Cut Function - Olimpia splendid UNICO EASY S1 Mode D'emploi

d. Press the key "SLEEP" on the remote control to stop the function; the icon on the control panel and on
the remote control display turn off.
3.12.c FOLLOW ME function
• This function can be activated only from the remote control.
• This function is not available while the Dehumidification (DRY) and Fan Only (FAN) modes are
active.
in this function, the remote control serves as a thermostat.
a. When the appliance is running, press the key "FOLLOW ME" on the remote control.
b. move with the remote control in an area of the room different from where the appliance is positioned
(maximum distance is 7÷8 metres) directing it towards the appliance itself and making sure there are no
obstacles between them.
c. Set the desired temperature on the remote control; the appliance works until it takes the temperature of
the area where the remote control is positioned to the value set on the remote control itself.
d. The remote control sends a signal to the appliance and, if it doesn't receive a response within a maximum
time of 7 minutes, the function deactivates.
e. Press the key "FOLLOW ME" on the remote control or switch the appliance off to stop the function.
3.12.d Setting the unit of measurement of temperature
it is possible to choose the set and environment temperature unit of measurement choosing between °C
(Celsius) or F (fahrenheit).
Work as follows:
On the control panel, press the keys + and - at the same time for approximately three seconds.
-
the desired unit of measurement appears on the display of the control panel.
- On the remote control, keep the central key TEMP pressed for approximately three seconds.
the desired unit of measurement appears on the display of the remote control.
The unit of measurement change must be performed both on the control panel and on the remote
control.
3.12.e Directing the air flow
• This function can be activated only from the remote control.
a. When the appliance starts, the flap opens completely.
b. Press the key "SWING" on the remote control and the flap starts oscillating automatically.
c. Press the key "SWING" to stop the flap in a certain position.
Press it again to restart oscillation.
3.12.f Short Cut function
• This function can be activated only from the remote control.
a. When the appliance is running in any of its modes, press the key "SHORT CUT" on the remote control
and the appliance automatically configures itself to "AUTO" with a set temperature of 26°C (80 f).
EN - 21
UNICO EASY S1