Set-Up & Adjustment; Swing-In/Swing-Out Hangers And Footrests; Heavy-Duty, Lift-Off Footrests - Quickie IRIS Mode D'emploi

E N G L I S H
NOTE– Setting the wheelchair on a table or on a flat surface, such as a workbench, helps make these proce-
dures easier.
NOTE ON TORQUE SETTING– A torque setting is the optimum tightening which should be made on a
particular fastener. A torque wrench which measures in./lbs. should be used when tightening fas-
teners on Quickie/Zippie wheelchairs. Unless otherwise noted, use a torque setting of 60 in./lbs.
When setting up this wheelchair.
A. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
1
(60°, 70º, 80°)
NOTE– 60° hangers are only available on the Zippie IRIS.
1
1. Installation
2. Removal
2
3. Height Adjustment
NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
B. HEAVY-DUTY, LIFT-OFF FOOTRESTS
1. Installation
2. Removal
3. Height-Adjustment, Front Mount
2
1
1
3
(optional)
13
IX. SET-UP & ADJUSTMENT
1
A
B
2
C
3
G
H
I
J