Getting Ready To Play And Demo Song; Getting Ready To Play; Connecting The Power; Silencing The Acoustic Piano Sound - Korg HT-70 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Getting ready to play and demo song

Getting ready to play

Connecting the power

1. Be sure that the HT-70 power is off.
2. Connect the included power cord to the included AC adapter, and plug the adapter's
DC plug into the DC12V connector on the HT-70.
Fig.1
to an AC outlet
Use the supplied AC adapter only. Use of another AC adapter may result in damage to the unit.

Silencing the acoustic piano sound

Use the muting unit to set or release the mute for the acoustic piano. Your muting unit
may be either electric (Fig. 2.1) or manual (Fig. 2.2). If the muting unit on your instrument
does not match either of these figures, please consult your dealer or a qualified service
agent for usage instructions.
All the functions of the HT-70 are available regardless of whether the acoustic piano is silenced.
The section "Using the HT-70 without silencing the acoustic piano" on page 25 describes some
ways to use the HT-70 together with the acoustic piano sound.
Even if the piano is silenced, there may be some leakage of the acoustic piano sound if you play
a chord strongly.
If you have an electric muting unit
To silence the piano, press in the switch on the muting unit located at
the base of the piano (Fig. 2.1), so that the switch is in the STOP posi-
tion. The "MUTING BAR" LED will light up to indicate that muting
is ON. To return to acoustic piano sound, press the switch again, so
that it pops out to the FREE position and the LED goes off.
Don't operate while you're playing.
If you have a manual muting unit...
As shown in Fig. 2.2, pull the lever of the mute unit located on
the bottom panel of the piano toward yourself, and lower the
lever to lock it into place. To go back to playing the acoustic
piano conventionally, return the lever to its original position.
Don't operate this lever while you're playing

Headphones

Headphone jacks are located on the front of the sound units (☞ p.5). These jacks accept
standard stereo headphone plugs.
Since there are two headphone jacks, two people can enjoy the sound of the piano.
On the model with speakers, plugging in headphones will mute the included speakers. Use head-
phones if the sound might be an annoyance to those nearby, such as when practicing at night.
Bottom panel of piano (HT-70 rear panel)
Power cable for AC adapter
...
AC adapter
DC plug
Fig. 2.1
Fig. 2.2
7

Publicité

Table des Matières

Dépannage

loading

Table des Matières