Safety - Simco-Ion Performax Easy Notice D'utilisation

3. Safety

The following safety guidelines must be observed in order to prevent physical injury and
damage to objects or to the anti-static bar itself.
Warning:
- The anti-static bar is only designed for neutralising electrostatically charged surfaces.
- Electrical installation and repairs must be carried out by a skilled electrical engineer
according to the applicable national and local regulations.
- The anti-static bar must only be powered by a Limited Power Source (LPS) or NEC Class 2
power supply.
- The equipment must be properly earthed. Earthing is required to ensure safe and proper
operation and to prevent electrical shocks upon contact.
- Disconnect the power supply before carrying out work on the unit.
- The emitters are sharp and can cause physical injury.
- During the ionisation process a small amount of ozone is produced. The ozone concentration
around the electrodes depends on a large number of factors, such as the amount of space
around the anti-static bar and the air circulation. This means that no general value can be
specified for the ozone concentration.
- If changes, adjustments etc. are made without prior written consent or if repairs are carried
out using non-original parts, the equipment's guarantee will no longer be valid.
- The Performax Easy and Performax Easy Speed are not intended to be used as safety
components in machines.
The high-voltage emitters (9 kV) are limited to a current of 90
electrically safe to touch and shockproof.
Performax Easy/Performax Easy Speed_UM_9752152130_NL_D_GB_F_V3_4

A, which means that they are
GB
35