CAMPAGNOLO ERGOPOWER QS ESCAPE Mode D'emploi page 15

• Pass the cable through the RH slot
on the cable guide plate located
underneath the bottom bracket box
(D - Fig. 16); insert the cable throu-
gh the pawl present on the chain
stay (A - Fig. 17).
• Fit a casing end (some frames require
the use of the special casing end - F
- Fig. 1 - Page 22) on the 330 mm
- diameter ø 4.5 mm casing, pass the
cable through the casing and insert it
in the pawl on the right chain stay (A
- Fig. 17).
• Fit a casing end to the other end
of the casing and secure the cable
to the rear derailleur (refer to the
rear derailleur instruction manual
for proper attachment of the cable
to the derailleur).
Front derailleur cable and casing
• Fit the end of the casing (330 mm
long - diameter ø 4.5 mm) with
the casing end already fitted in the
external slot of the LH Ergopower™
control unit (Fig. 11 - Page 26).
• Set the control at the smallest chain-
ring position by pressing lever (A
- Fig. 18) repeatedly and fit the
front derailleur cable (1,600 mm long
- diameter ø 1.2 mm) in the appro-
priate hole (B - Fig. 19).
• Cut the casing so that it reaches the
casing retainer clamp on the frame
(A - Fig. 20).
16
�
17
�
�
18
19
�
28
WARNING!
Before cutting the casing, carefully
check that the length you choose is
suitable for the size of your frame.
Insufficient slack in the cable and
casing could affect your ability to
turn or control your bicycle, resul-
ting in an accident, personal injury
or death.
• After cutting the casing at the
suitable length, fit a casing end
and insert the casing in the casing
retainer clamp (A - Fig. 20) on the
frame.
• Let the cable run into the casing.
• Pass the cable through the LH slot
on the cable guide plate (B - Fig.
21) located underneath the bottom
bracket box and secure the cable
to the front derailleur (refer to the
derailleur instruction manual for
proper attachment of the cable to
the front derailleur).
Adjusting the cable tension
• Rear derailleur cable tension can
be modified by turning the adjuster
(A - Fig. 22) on the casing retainer
clamp (not included in the pack) or
by using the adjuster (B - Fig. 23)
placed on the rear derailleur body.
• Front derailleur cable tension can
only be modified with the adjuster
(A - Fig. 22) on the casing retainer
clamp (not included in the pack) or
by means of the adjustment system
envisaged by the frame manufac-
turer.
29
20
�
21
�
22
�
23
�