Publicité
Les langues disponibles
Les langues disponibles
- the control unit should also be
correctly oriented to avoid affec-
ting bicycle aerodynamics (Fig. 5).
Note
The gap between the control lever
and the handlebars must ensure
suitable grip as well as sufficient
lever movement for correct braking
power (Fig. 7).
• Secure the control on to the han-
dlebar by tightening the 5 mm
Allen screw (B - Fig. 2 - Page 5) to
10 N.m using a torque wrench.
• Please note that the functioning of
your Ergopower™ control levers is
dependent on the shape of the hand-
lebars. If the drop outs are not com-
patible with the Ergopower™ control
levers shape, the Ergopower™ con-
trol levers may not function properly
(see Fig. 7).
• If necessary, install the casing
retainer clamps (not included in
the pack – available as spare part,
code no.
EC-RE001 in alumi-
nium and EC-AT001 in resin) on
the square bosses on the frame
(Fig. 6).
Note
7
Carbon
frames
might need spe-
cial casing retai-
ner clamps, avai-
lable
as
spare
NO!
parts (in alumi-
nium – code no.
EC-RE002).
5
���
����
���
6
YES!
24
3 . F I T T I N G T H E D R I V E T R A I N S
• Install the cable guide plate (inclu-
ded in the pack) under the bottom
bracket shell, as follows:
- position the washer (A – Fig. 8) in
the provided seat in the cable guide
plate.
- place the cable guide plate under
the bottom bracket shell and fix it
by means of the provided screw (B
– Fig. 8) with a torque of 3-4 Nm.
• The cable casings of the rear derail-
leur (A - Fig. 9) have a diameter
of 4.5 mm, while the brake cable
casings (B - Fig. 9) have a diameter
of 5 mm.
• Depending on your frame, it may
be necessary to cut the rear brake
casing and install a casing lead end
(not supplied in your Ergopower™
control levers package).
NOTES
1) The casing must be cut so
that the end is perpendicular to
the legth (Fig. 10). In addition,
the cross section of the casing
must not change. After cutting the
casing, check that you have resto-
red its roundness to ensure that
there is no friction between the
cable and casing.
WARNING!
Before cutting the casing, care-
fully check that the length you
choose is suitable for the size
of your frame. Insufficient slack
in the cable and casing could affect your ability to turn or control
your bicycle, resulting in an accident, personal injury or death.
25
8
B
A
9
�
�
��������
������
10
���
����
���
���
Publicité
