Treatment Plan - Silk-n Lipo Mode D'emploi

4.5 Device charging
Charge each treatment unit before first use. The initial charge should take
around 6 hours. Subsequent charges should take around 3 hours. We recommend
you recharge the device before each treatment.
EN
Remove the electrode pads before placing the treatment units in the
1.
stand/charging cradle.
Connect the empty stand/charging cradle to the electricity supply. The
2.
2 charging indicator lights will be constant green.
Place each treatment unit in the cradle so that it sits in the designated
3.
grooves.
y
y
Once charged, disconnect the stand/charging cradle from the electricity
4.
supply.
5.

Treatment plan

C
For use on clean, healthy skin (see section "1. Warnings & contraindications").
U
Treat the target area for 15 minutes per treatment session (see illustration).
U
For larger parts of the body, like the stomach or buttocks, you may wish to
move the treatment unit to an adjacent part of the target area, and use
for another 15 minutes. You may keep doing this until you have covered
the target area.
U
Try to avoid gaps and overlaps.
U
Never use Silk'n Lipo on exactly the same spot during a treatment session.
U
For daily use, but no more than 3 times a week on each specific target area.
Continue until you get the results you want.
When the treatment unit is charging, the orange battery/error
indicator light on the treatment unit will flash on and off.
When fully charged the battery/error indicator light (left) will go
off, and the green operating light (middle) will be constant green.
14