Handling The Card And Its Cable; Handling The Card; Connecting The Cable To The Card; Disconnecting The Cable - Digigram VXpocket 440 Manuel Utilisateur

D i g i g r a m

HANDLING THE CARD

HANDLING THE CARD AND ITS CABLE

HANDLING THE CARD HANDLING THE CARD
Handling the card
The card ought always to be handled with care and is not to be exposed to
shocks. It is recommended to transport it either inserted in the computer,
or in its original sleeve.

Connecting the cable to the card

To connect the cable to your VXpocket 440, place the connector of the
cable in a horizontal position, opposite to the card with the arrows on top
(see diagram below). Then insert the cable into the female part of the card
until it is completely plugged in.
To avoid any tensions on the connector and thus on the card, it is strongly
recommended to screw the cable to the back of the laptop (for example on
the parallel port) using the two screws provided for this purpose.

Disconnecting the cable

To disconnect the cable from the card, simultaneously press the buttons on
both sides of the connector with thumb and forefinger. These buttons are
marked with arrows. Then withdraw the cable of the card while
maintaining the two buttons pushed. Then detach the support screws of
cable on the back of the laptop.

HARDWARE INSTALLATION

HARDWARE INSTALLATION
HARDWARE INSTALLATION HARDWARE INSTALLATION

Installing the card

Smoothly insert the card into a free PC card slot. Press to set it firmly into
the slot.

Interrupt and memory addresses

Under Windows 98 SE, Millennium, 2000, XP, and Mac OS, interrupt
request, and memory addresses used by the card are automatically set at
system start-up.
Under Windows NT 4 it is necessary to manually select these parameters
during driver installation (see section "software installation"), as Windows
NT 4 is not a plug and play operating system.
10
AND ITS CABLE AND ITS CABLE AND ITS CABLE