General Configuration; Always On Top Of The Display; Resetting The Faders To Their Default Values; Selecting The Input/Output Mixer Channel - Digigram VXpocket 440 Manuel Utilisateur

D i g i g r a m

General configuration

The mixer configuration options allow selection of: input and output
nominal level, input and output headroom, input type.
The input and output nominal level and input and output headroom
define the maximum value of the acceptable input signal. Set the nominal
level to the currently used nominal level. The headroom should be set to
avoid any risk of overload. If set beyond the installed card's capabilities,
the driver automatically sets the correct values. In this case, the displayed
values are wrong.
The Input Type selection allows selecting Digital Input, Analogue Input or
Automatic Selection. In this last case, Digital Input is selected whenever a
signal is present.

Always on top of the display

Right click on the Mixer icon in the taskbar, or go to the Mixer <Options>
menu.
Select Always on top Always on top Always on top. Always on top

Resetting the faders to their default values

Click on the <Options Options Options> menu. Options
Select Reset levels Reset levels Reset levels. Reset levels

Selecting the input/output mixer channel

Click on the Mixer menu.
Select the required board and channel Mixer.

Setting the default values for each mixer line selected

Right click on the Mixer icon in the taskbar, or go to the Mixer <Options>
menu.
Select Save current configuration as default Save current configuration as default Save current configuration as default. Save current configuration as default
Getting the default configuration values for the mixer line
selected
Right click on the Mixer icon in the taskbar, or go to the Mixer <Options>
menu.
Select Load default configuration Load default configuration Load default configuration. Load default configuration

Leaving the mixer program

Click on the right button over the Mixer icon in the taskbar.
Select Exit Exit. Exit Exit

General settings

Record source

Buttons allow selecting the input type.
Digital input: selects the digital input, only digital gain can be applied. Digital input:
Digital input: Digital input:
22
Options> Options> Options>
Options> Options> Options>
Options> Options> Options>