Asio Control Panel For Pc; General Settings; Active Stereo I/O; Clock - Digigram VXpocket 440 Manuel Utilisateur

Les langues disponibles

i g i g r a m

ASIO CONTROL PANEL FOR PC

The purpose of this control panel is to set all the parameters of your

Digigram card when used with its ASIO driver. It must be launched from

the ASIO compatible application you use.

Detected Digigram boards are displayed in the left upper corner with their

serial number and their I/O stereo pairs. General settings of the selected

card are displayed in the right upper corner. IN and OUT settings of the

selected device are displayed underneath.

It is recommended to activate only the I/O required to save CPU resources.

The clock corresponds to the digital bit clock to which the card refers.

When an analog input is selected, the s s s s ource

clock or taken from the digital input. As soon as the digital input is

selected, the clock is read from this input.

The frequency

frequency flip menu allows selecting the sampling frequency of the

frequency

selected card: 32, 44.1 or 48 kHz. It must be set according to the sampling

frequency of the project you are working on.

ource can be either the internal

ource

Table des Matières