EUROM E-CONVECT METAL Manuel D'utilisation page 18

Safety features
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially) covering
the heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar. In case of overheating, switch off the heater and
unplug. Give the heater time to cool down, remove the source of the overheating and
use as normal. If the problem persists or if you have not been able to trace the
source of the overheating, turn the heater off immediately and unplug. Contact a
servicing point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning or
carrying out maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not
use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!

Use a vacuum cleaner to carefully remove any dust and dirt from the grills and
ensure that the air intake and outlet openings are clean. Be careful not to touch
or damage any internal parts during cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if
possible. Store it upright in a cool, dry and dust-free place.

Do not dispose of heater with household waste when it becomes worn or
damaged beyond repair. Take it to your local authority's collection point for
electrical appliances where any reusable materials will be collected and
redistributed.
CE-statement
Euromac bv, Genemuiden-NL hereby declares that the EUROM electrical
convector heater, type E-CONVECT METAL, complies with the LVD guideline
2006/95/EG and the EMC guideline 2004/108/EC and meets the following standards:
EN 55014-1 :2006, A1 :2009
EN 55014-2:1997, A1:2001, A2:2008
EN 61000-3-2 :2006, A1:2009, A2:2009
EN 61000-3-3 :2008
Genemuiden, 28-06-2013
W.J. Bakker, alg.dir.
EN 60335-2-30 :2009+A11 :2012
EN 60335-1 :2012
EN 62233:2008
18