EUROM E-CONVECT METAL Manuel D'utilisation page 17

Mounted (secured to a wall):
Choose a solid, flat and completely
vertical wall made of non-flammable
and non-melting material on which to
mount the heater (i.e. no wood,
synthetic materials, etc!)

Decide where you want to mount
the heater. Make sure that the
heater has
around it at all times and that no
inflammable materials are located nearby (see
also safety instructions). Do not place the heater
behind a door! The heater's underside needs to
be at least 5 cm and max. 10 cm above the
floor, the sides at least 20 cm from the side
walls and the top at least 200 cm from the
ceiling, ceiling beams, etcetera.
 Attach the two hanging brackets to the wall. To
do so, drill (with a suitable drill) 2 holes 520 mm
apart, at least 35 cm from the floor, on a
completely horizontal line. Insert plugs. Screw
two long screws into the plugs until they
protrude by 8 mm.
 Secure the two fixing brackets underneath the heater. Then
position the small hole in the long side of the bracket over the
rear hole in the base of the heater, with the brackets' short
sides pointing towards the floor and jutting out from the heater
in a straight line. Attach securely using the small screws.

Slide the heater, with the gaps in the rear, over the suspension
brackets and lower the heater into the grooves. The fixing
brackets will ensure there is enough space between heater
and wall.

Mark the place where the fixing brackets need to be fixed to
the wall. Take the heater down, drill holes and attach plugs at
the marked spots. Mount the heater and screw in the fixing
brackets with the two remaining long screws.
Set-up and Operation

Make sure the heater is turned off and that the thermostat dial is set to maximum
(clockwise, as far as it will go). Now plug into an earthed, correctly functioning
220-240V / 50Hz socket. Only connect the heater to an earthed socket!
Turn the heater on by pushing the on/off switch to 'on' (I pushed in). The heater

will now begin to disseminate hot air.

When the space has reached the desired temperature, turn the thermostat dial
anticlockwise slowly until you hear a click. In this position, the thermostat will
maintain the current temperature by turning the heater on and off for a top-up, if
necessary. For higher temperatures, turn the thermostat dial clockwise, for lower
temperatures anticlockwise.
 To switch off, click the ON / OFF-switch to off. The heater switches off. Unplug.
sufficient space
17