Scope Of Use - Parkside EURO 270/8/24 Mode D'emploi

Anleitung_Euro_270_8_24_mehrspr:_
GB
1. Layout (Figures 1/2/3)
1. Intake air filter
2. Pressure vessel
3. Wheel
4. Oil level window
5. Safety valve
6. Quick-lock coupling (unregulated
compressed air)
7. Pressure regulator
8. Quick-lock coupling
(regulated compressed air)
9. Pressure gauge
(for reading the tank pressure)
10. Pressure switch
11. Transportation handle
12. ON/OFF switch
13. Oil sealing plug (oil filler opening)
14. Pressure gauge
(for reading the preset tank pressure)
15. Oil drainage screw
16. Non-return valve
17. Supporting foot
18. Drain valve
19. Compressor
Important!
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete
operating manual with due care. Keep this
manual in a safe place, so that the information
is available at all times. If you give the
equipment to any other person, give them
these operating instructions as well.
We cannot accept any liability for damage or
accidents which arise due to a failure to follow
these instructions and the safety instructions.

2. Scope of use

The compressor is designed for generating
compressed air for tools operated by
compressed air.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
18
08.06.2007 9:58 Uhr Seite 18
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.
3. Points to note when setting
up the compressor
Examine the machine for signs of transit
damage. Report any damage immediately
to the company which delivered the
compressor.
Before you put the compressor into
operation, check the oil level in the
compressor pump.
The compressor should be set up near the
working consumer.
Avoid long air lines and long supply lines
(extensions).
Make sure the intake air is dry and dust-
free.
Do not set up the compressor in damp or
wet rooms.
The compressor may only be used in
suitable rooms (with good ventilation and
an ambient temperature from +5°C to
+40°C). There must be no dust, acids,
vapors, explosive gases or inflammable
gases in the room.
The compressor is designed to be used in
dry rooms. It is prohibited to use the
compressor in areas where work is
conducted with sprayed water.
4. Safety instructions
4.1 General safety instructions
Important! The following basic safety
precautions have to be taken when using
this compressor in order to guard against
the risk of electric shock, injury and fire.
Read and note these instructions before
you use the compressor.
1. Keep your work area tidy
- There is a higher risk of accident in an
untidy work area.