Safety Information; Items Supplied - Parkside EURO 270/8/24 Mode D'emploi

Anleitung_Euro_270_8_24_mehrspr:_
GB
4.2 Safety instructions for working with
copressed air and blasting guns
Compressors and lines reach high
temperatures during operation. Avoid
contact! Risk of burns!
Gases or vapours drawn in by the
compressor have to be kept free of
constituents that may cause fire or
explosions inside the compressor.
When you disconnect the hose coupling,
hold the coupling element in your hand to
prevent injury from the whiplashing hose.
Wear goggles when working with the blow-
out gun. Injuries may easily result from
foreign bodies and blasted parts.
Never point the blow-out gun at other
persons and never use it to clean clothes
that are still being worn.
4.3. Safety information for paint spraying
Never process paints or solvents with a
flash point below 55°C.
Do not heat lacquers and solvents as they
are highly inflammable.
It is imperative to use filtering equipment
(face masks) when processing harmful
liquids. Note also the information
concerning safety precautions published by
the manufacturers of these liquids.
Smoking is prohibited during the spraying
operation and in the work room. Paint
vapours are highly flammable.
Make sure there are no open fires or open
lights in the work room. Sparking machines
are not to be used.
Do not keep or consume food and drink in
the work room. Paint vapours are harmful.
The details and designations of the
Ordinance on Hazardous Substances,
which are displayed on the outer packaging
of the processed material, must be
observed. Additional protective measures
are to be undertaken if necessary,
particularly the wearing of suitable clothing
and masks.
The work room has to be bigger than 30 m
and have sufficient ventilation for spraying
and drying. Never spray into the wind.
It is always imperative to observe the
20
08.06.2007 9:58 Uhr Seite 20
regulations of your local police authorities
when spraying combustible or hazardous
substances.
Never process media such as white
petroleum spirit, butyl alcohol and
methylene chloride with the PVC pressure
hose (reduced life span).
4.4 Operating pressure vessels
An operator of a pressure vessel is
required to keep the pressure vessel in
good working order, to operate it properly,
to supervise its use, to carry out essential
maintenance and repair work immediately,
and to introduce essential safety measures
according to requirements.
The supervisory authorities may order
essential safeguards from case to case.
A pressure vessel may not be operated if it
has any defects which constitute a danger
to employees or third parties.
The pressure vessel must be regularly
inspected for damage, e.g. rust. If you
discover any damage, then please contact
the customer service workshop.
Keep these safety instructions in a safe
place.

5. Items supplied

2 x Wheel (3)
2 x Fastening material for the wheels (a)
1 x Oil sealing stopper (13)
1 x Foot (17)
1 x Air filter (1)
1 x 5-piece accessory set
1 x 8-piece adapter set
3