Publicité
Les langues disponibles
Les langues disponibles
P P
a a
r r
t t
1 1
: :
F F
P P
a a
r r
t t
1 1
: :
F F
H H O O W W T T O O C C H H A A N N G G E E T T H H E E T T Y Y P P E E O O F F G G A A S S U U S S E E D D B B Y Y T T H H E E H H O O B B
NETWORK GAS
(NATURAL GAS)
Meter
BEFORE YOU START
•
In France, this hob can also be adapted to
propane/air and butane/air. The adaptation pack is
supplied upon request by your After Sales Service
Deptartment.
Injector
Dish
Spanner
Line
fig.3
fig. 5
o o
r r
t t
h h
e e
i i
n n
s s
o o
r r
t t
h h
e e
i i
n n
s s
Disconnect the appliance first!
BUTANE/PROPANE
Pressure regulator
compulsory
propane
butane propane
fig.1
Angle spanner
Hearth plate
fig.2
Line
fig.4
Spanner
Retarder
screw
Tap axis
t t
a a
l l
l l
e e
r r
t t
a a
l l
l l
e e
r r
CHANGING FROM BUTANE / PROPANE GAS
TO NATURAL GAS OR AIR-PROPANE/ AIR-
BUTANE (FIG. 1)
When carrying out this operation, you should
successively :
A
DAPT THE HOB CONNECTION
justment. Refer to the paragraph"how to connect the
hob to the gas supply (natural gas)".
C
HANGE THE INJECTORS
• Remove the supports, and all the burner caps and
heads.
• Using the spanner supplied, unscrew the injectors
at the bottom of each dish and remove them (fig. 2).
• Replace these with the injectors supplied in the
bag, in accordance with the gas characteristics
table ; To do this :
Screw them first manually.
Put the spanner well onto the injector.
Scew them up to tightening (not forced).
With a pencil draw a line on the hearth plate as
indicated (fig. 3).
Turn the spanner clockwise until the line appears on
the other side (fig. 4).
• · Replace the heads, caps and grids of all the
burners.
A
DJUST THE RETARDER ON THE TAPS
under the knobs. Proceed as follows :
• Work on one burner at a time :
- light the burner and turn the knob to maximum
position,
- remove the knob of the corresponding tap,
- using a screwdriver, unscrew the brass retarder ad-
justment screw (yellow) (fig. 5) by two anticlockwise
rotations.
- put back the knob, and turn it to minimum
position,
- remove the knob again then turn the adjustment
screw clockwise as low as possible without
extinguishing the flames,
- put back the knob then turn it several times from
maximum position to minimum position : the flame
must not be extinguished. Otherwise, re-adjust it by
slightly screwing or unscrewing the adjustment screw
so that a stable flame is obtained when the knob is
turned from maximum to minimum position.
-19-
A
DAPT THE GAS CONNECTION
C
HANGE THE INJECTORS
A
DJUST THE RETARDER ON THE TAPS
to the new gas ad-
in the following way :
located
Publicité
