Pelgrim IDK764 Notice D'utilisation page 40

TROUBLESHOOTING
Symptom
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
The hob simply switches off.
Fault code ER22.
Fault code E2.
Fault code E3.
Fault code U400.
Fault code .
Other fault codes.
EN 20
Possible cause
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
You accidentally touched the
On/Off button.
The control panel is filthy or
has water on it.
The hob has overheated.
The pan you are using is not
suitable.
The voltage is too high and/
or the hob is not properly
connected.
An identified permanent use
of the slider area or buttons.
Defective generator.
Solution
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Switch the hob back on.
Clean control panel.
Let the hob cool down and
then use a lower setting.
Use a suitable pan.
Have your connection
changed.
Do not touch a multi slider or
a button too long.
Contact the service
department.