Saving The Program Parameters (Write); Chain Mode - Korg BEATLAB BTL-1 Mode D'emploi

Saving the program parameters (WRITE)

You can save the settings of the program pa-
rameters in the BEATLAB memory. If selecting
other program or moving to another mode be-
fore saving the current parameter setting, the
chain setting will be returned to the previous one.
Be sure to save your important programs in the
memory by carrying out the writing operation.
(1) Press the WRITE key after setting the pa-
rameters.
The BEATLAB goes to the program selec-
tion state, and the program number blinks s
on the display.
(2) Enter the program number where the settings
are to be saved using the
the numeric keys.
Note: Once the writing operation is ex-
ecuted, the program currently saved
in the selected program number is
overwritten.
12
(3) Press the WRITE key.
Press the CHAIN key to enter the chain mode.
In the chain mode, you can continuously replay
one program after another, which has been
saved in the program mode.
and keys or
- The BEATLAB offers eight chains, each of
To cancel the writing operation, press
either the parameter selection key or
the mode key.
The parameters are saved and "EDIT" dis-
appears from the display.

Chain Mode

which consists of one TEMPO and up to 16
BARS.
You can enter only one program number in one
bar.