Training Mode; Selecting The Training Pattern; Starting/Stopping The Training Pattern - Korg BEATLAB BTL-1 Mode D'emploi

state, and the chain number blinks on the
display.
(2) Enter the chain number where the settings
are to be saved using the
the numeric keys.
Note: Once the writing operation is ex-
ecuted, the setting currently saved in
the selected chain number is overwrit-
ten.
To cancel the writing operation, press
either the parameter selection key or
the mode key.
(3) Press the WRITE key.
The parameters are saved and "EDIT" dis-
appears from the LC display.

Training Mode

Press the TRAINING key to enter the training
mode.
In the training mode, 39 training patterns ideal for
snare drum practice are preset. You can replay
them and adjust their tempos while replaying.
In the training mode, the sounds and the LEDs
guide you to beat correct time.
and keys or The high note sound is generated and the green
LED blinks at the timing of right hand beat. The
low note sound is generated and the red LED
blinks at the timing of left hand beat.

Selecting the training pattern

(1) In the training mode, press the parameter
(2) Select the training number using the

Starting/stopping the training pattern

(1) Press the START/STOP key to start replay
(2) Press the START/STOP key to stop replay
selection key positioned under "TRAINING."
keys or the numeric keys. Specify the train-
ing number by two digits.
of the training pattern.
The reference beat is given first and followed
by the training pattern.
of the training pattern while it is being re-
played.
and
17