Cleaning / Maintenance; Replacing The Dust Bag - Renfert Silent TS2 Mode D'emploi

Set shut-off delay B
♦ The letter B is indicated.
♦ The display shows the current shut-off delay setting for suction hose B.
⇒ Set the required shut-off delay with the
⇒ Press enter button (40).
Set shut off delay A and B
♦ The letters A and B are indicated.
♦ The display shows the current shut-off delay setting.
⇒ Set the required shut-off delay with the
⇒ Press enter button (40).
The shut-off delay adjustment can be quit at any time before or after the value is saved, by pressing
EN
the menu key (30).
Whilst setting the shut-off delay, press the
shut-off delay parameter.

6. Cleaning / Maintenance

Inside the appliance there are no parts which require maintenance.
Opening the device, other than for the processes described below, is not permissible!
6.1

Replacing the Dust Bag

The set dust bag fill level has been reached:
♦ The dust drawer symbol (33, Fig. 2) blinks.
♦ An audible signal will be emitted 3 x.
♦ The display blinks "Cod01".
Emptying the dust drawer:
⇒ Switch the extractor off.
⇒ Pull the front panel forward and off (5, Fig. 1).
⇒ Pull the dust drawer (7) out towards the front.
⇒ Remove the protective film from the glue flap and use it to
cover the dust bag opening!
⇒ Dispose of the dust bag properly.
⇒ Insert a new dust bag into the dust drawer. Ensure that the
new dust bag is properly aligned in the guide grooves (21)
and the glue flap faces upwards.
Use only original Renfert dust bags (see spare parts list).
⇒ Inspect the dust drawer seal for damage and replace it, as
required (24).
⇒ Insert the dust drawer, making sure it is straight, and push it in as far
as it will go. Make sure that the dust drawer is seated correctly on
the guide (23, Fig. 16).
⇒ Install the front panel (5, Fig. 1) on the bottom hooks then push it
into the upper lock bolts (22, Fig. 16), pressing firmly until it locks in
place.
/ buttons (41, 43).
/ buttons (41, 43).
/ buttons together to return to the factory set
- 14 -
22
7
23
Fig. 16
21
Fig. 17
24
Fig. 18