Siebert S102 Série Mode D'emploi page 35

Display test
In menu item F you can set whether a short-time display test is automatically carried
out after power-on.
The display test can also be activated via the Modbus interface by setting bit 7 in byte 0.
The display test has priority over blanking and flashing.
Demo operation mode
If in menu item F the setting PlAy is selected, random characters are displayed
one after another. A control of the unit is in this operation mode not possible.
Power-on reset
After the operating voltage is applied, minus signs appear in all decades in order to
signal operational readiness of the unit. If a display test has been preselected in the
menu, it runs beforehand.
Character set
In addition to the numbers 0...9, the character set also contains the other characters
that can be displayed with a 7-segment matrix. They are reproduced in the table
below with the corresponding hex code.
20/2B 2D 30
- 0
41/61 42/62 43
A b C
55 59/79 5F
U Y _
BAL S102 MDB M 1.0
31 32 33
1 2 3
44/64 45/65 46/66 47/67
d E F
63 68 69
i
c h
34 35 36
4 5 6
48 49
'
G H
4E/6E 4F/6F 52/72 54/74
n o r
37 38 39
7 8 9
4A/6A 4C/6C 4D
J L M
75 58/78
t u €
2C/2E
.
50/70
P
other
y
35