HumanTechnik Signolux Mode D'emploi page 8

Connecting two recharging bases
with each other
Bridge-
element
1. Unplug the two recharging bases.
2. Detach a bridge element from the
bottom of one of the bases.
3. On the first recharging base, remove
one of the plastic covers over the
slot for the bridge element. Insert the
bridge element into the slot.
4. Screw the safety screw into the
bridge element through the bot-
tom of the base.
5. Remove the opposite plastic cover
on the second recharging base.
6. Set the second recharging base
on the bridge element protruding
out of the first recharging base.
7. Push the second recharging base
over until it is flush with the first one.
8. Screw the safety screw into the
bridge element through the bot-
tom of the second recharging
base.
9. Plug in one of the recharging
bases into a power outlet by inser-
ting the round plug into the DC jack
on the back of the recharging base.
8 English
Use only one power supply unit to
plug in the two recharging bases!
Maintenance and care
All Signolux devices are maintenan-
cefree. If the unit does become dirty,
simply wipe it clean with a soft, damp
cloth. Never use spirits, thinners or
other organic solvents.
Please do not expose Signolux devi-
ces to direct sunlight for a long time
and please protect them from exces-
sive heat, moisture and severe
mechanical shocks.
Note: This product is not protected
against splash water. Do not place
any containers filled with water, such
as flower vases, or anything with an
open flame, such as a lit candle, on or
near the product.