HumanTechnik Signolux Mode D'emploi page 7

We would like to congratulate you on
the purchase of the recharging base
for the portable Signolux receiver and
hope it will serve you for a long time
to come.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system's features
to you.
Standard components
Please check if all following compo-
nents are included:
- Recharging base with bridge
element and 4 safety screws
- 2 x NiMH rechargeable batteries
(Type AAA)
- Power supply unit
- Operating instructions
- Guarantee card
If any parts are missing, please imme-
diately contact your dealer or the
manufacturer directly.
How to Start
1. Please first remove the batteries
from the Signolux receiver and
replace them with the included
rechargeable batteries with the base.
2. Connect the recharging base with
the power supply by inserting the
round plug into the DC jack on the
back of the recharging base.
3. Plug the power cord into a 230-
volt power outlet.
Rechargeable Batteries
The recharging base comes with 2
NiMH rechargeable batteries. If the
rechargeable batteries are properly
charged and discharged, they will
have a long service life.
Please make sure that the batteries
are inserted correctly in the battery
compartment of the portable signolux
receiver. The illustration on the bot-
tom of the battery compartment indi-
cates the correct direction.
Please note that the rechargeable bat-
teries are not charged on delivery and
must be completely charged (at least
10 hours) in the portable signolux
receiver in the recharging base first.
To recharge your portable signolux
receiver, please use only the rechar-
geable batteries included with the
recharging base or the rechargeable
batteries that are available as special
accessories (A-2994-0).
English 7