Olimpia splendid UNICO TWIN Instructions Pour L'installation, L'emploi Et L'entretien page 37

1. The appliance may be used by children over 8 years of age and by persons with re
duced physical, sensorial or mental capacities, or without the required experience
or knowledge, provided they are supervised or have been instructed in the safe use
of the appliance and understand the hazards involved.
2. Children must not play with the equipment.
3. Children must not be allowed to clean the appliance or perform user maintenance
without proper supervision.
4. If the power cable is damaged, it must be replaced by the manufacturer or by its technical support
service or by similarly qualified personnel, to prevent any risk to the user.
5. Installation, initial start-up and subsequent maintenance, with the exception of the
ambient air filter cleaning and washing, must be carried out solely by authorised and
qualified personnel.
6. To prevent the risk of an electric shock it is mandatory to switch off the main switch
before performing the electrical connections or any maintenance operation to the
appliances.
7. During installation, comply with the minimum clearances shown in Figure 5.
8. During the appliance electrical connection, following the indications shown in
Fig. 42.
1 GENERAL ...................................................................................................................................................................................................... 38
1.1 SYMBOLS ...................................................................................................................................................................................................... 38
1.1.1 Editorial pictograms ......................................................................................................................................................................... 38
1.1.2 Safety pictograms ............................................................................................................................................................................ 38
1.2 GENERAL INFORMATION ............................................................................................................................................................................ 38
1.3 WARNING ...................................................................................................................................................................................................... 39
1.4 LIST OF PACKING COMPONENTS .............................................................................................................................................................. 39
1.4.1 Storage ............................................................................................................................................................................................ 40
1.4.2 Receipt and unpacking .................................................................................................................................................................... 40
1.5 UNIT ELEMENTS ........................................................................................................................................................................................... 40
2 INSTALLATION .............................................................................................................................................................................................. 41
2.1 UNICO MASTER INSTALLATION PROCEDURES ....................................................................................................................................... 41
2.1.1 Size and specifications of the room in which to install the air conditioner ....................................................................................... 41
2.1.2 Choosing the position of the unit ..................................................................................................................................................... 41
2.1.3 Unit assembly .................................................................................................................................................................................. 41
2.1.4 Warning............................................................................................................................................................................................ 41
2.1.5 Drilling the wall ................................................................................................................................................................................. 41
2.1.6 Preparing the condensate discharge ............................................................................................................................................... 42
2.1.7 Assembly of the air ducts and external grids ................................................................................................................................... 42
2.1.8 Preparing the holes on the machine ................................................................................................................................................ 43
2.1.9 Fitting the unit on the bracket .......................................................................................................................................................... 43
2.1.10 UNICO MASTER electrical connection ............................................................................................................................................ 43
2.1.11 Top/bottom installation configuration ............................................................................................................................................... 44
2.1.12 UNICO MASTER running tests and troubleshooting ....................................................................................................................... 44
2.1.13 Evacuating condensate water during an emergency ....................................................................................................................... 45
2.2 WALL SPLIT INSTALLATION PROCEDURES ............................................................................................................................................. 45
2.2.1 Instructions for installation ............................................................................................................................................................... 45
2.2.2 Choice of position for WALL SPLIT unit ........................................................................................................................................... 46
2.2.3 Installation of fastening plate ........................................................................................................................................................... 46
2.2.4 Drilling pipe passage holes .............................................................................................................................................................. 46
2.2.5 Installation of unit ............................................................................................................................................................................. 46
2.2.6 Connecting the indoor unit condensation discharge line ................................................................................................................. 46
2.2.7 Cooler connection ............................................................................................................................................................................ 47
2.2.8 Tests and inspection ........................................................................................................................................................................ 47
2.2.9 System vacuum ............................................................................................................................................................................... 48
2.2.10 Filling the system ............................................................................................................................................................................. 48
2.2.11 WALL SPLIT electrical connection ................................................................................................................................................... 48
2.2.12 WALL SPLIT running tests and troubleshooting .............................................................................................................................. 48
2.3 UNICO MASTER AND WALL SPLIT COMMUNICATION LINE ..................................................................................................................... 49
2.3.1 Communication between the two units ............................................................................................................................................ 49
2.4 ROUTINE MAINTENANCE ............................................................................................................................................................................ 49
2.4.1 Cleaning the air filter ........................................................................................................................................................................ 50
2.5 DELIVERY OF THE SYSTEM ........................................................................................................................................................................ 50
3 USE AND MAINTENANCE (USER PART) .................................................................................................................................................... 51
3.1 WARNINGS .................................................................................................................................................................................................... 51
3.1.1 Components of the system .............................................................................................................................................................. 51
3.1.2 Description of the warning panel of UNICO MASTER and WALL SPLIT ........................................................................................ 51
3.2 MANAGEMENT OF UNICO MASTER AND WALL SPLIT UNITS WITH REMOTE CONTROL .................................................................... 51
3.2.1 Remote control ................................................................................................................................................................................ 51
3.2.2 Fitting the batteries .......................................................................................................................................................................... 52
3.3 UNICO MASTER AND WALL SPLIT REMOTE CONTROL ........................................................................................................................... 52
3.3.1 Description of the remote control ..................................................................................................................................................... 52
3.3.2 General power-on and management of UNICO MASTER and WALL SPLIT .................................................................................. 52
3.3.3 Turning the unit ON/OFF ................................................................................................................................................................. 52
3.3.4 Well-being key (automatic operating) .............................................................................................................................................. 53
3.3.5 Cooling ............................................................................................................................................................................................. 53
3.3.6 Dehumidification only ....................................................................................................................................................................... 53
3.3.7 Ventilation only ................................................................................................................................................................................. 53
3.3.8 Heating (only models fitted with heating pump) ............................................................................................................................... 53
3.3.9 Air flow direction control ................................................................................................................................................................... 53
3.3.10 Checking fan speed ......................................................................................................................................................................... 53
3.3.11 Night well-being key ......................................................................................................................................................................... 54
3.3.12 Setting the operating programs ....................................................................................................................................................... 54
3.3.13 Setting the exact time ...................................................................................................................................................................... 54
3.3.14 Setting the times of the 1st and 2nd the operating programs (PROGR. 1 and PROGR. 2) ............................................................ 54
3.3.15 Starting and stopping the operating programs ................................................................................................................................. 54
3.3.16 Resetting all remote control functions .............................................................................................................................................. 55
3.3.17 Managing the unit if the remote control is not available ................................................................................................................... 55
3.4 ENERGY SAVING ADVICE ............................................................................................................................................................................ 55
3.5 DIAGNOSIS OF THE PROBLEMS ................................................................................................................................................................ 55
3.5.1 Functional aspects not to be interpreted as problems ..................................................................................................................... 55
3.5.2 Troubleshooting ............................................................................................................................................................................... 56
3.5.3 Specifications ................................................................................................................................................................................... 56
WARNINGS
1
37
UNICO TWIN