Troubleshooting; Specifications - Olimpia splendid UNICO TWIN Instructions Pour L'installation, L'emploi Et L'entretien

3
3.5.2

Troubleshooting

In case of malfunctions, check the following table.
If the problem persists after the suggested checks and controls, contact the authorised technical service.
FAULTS
The unit does not turn on
The unit does not cool or
heat adequately
3.5.3

Specifications

For the technical data listed below, consult the characteristic data plate applied to the product
- Power supply voltage
- Maximum power absorbed
- Maximum current absorbed
- Coolant gas
- Protection rating of the containers
- Max working pressure
Dimensions (W x H x D)
Weight (without packing)
Maximum operating temperature in cooling mode
Minimum operating temperature in cooling mode
Maximum operating temperatures in heating
Minimum operating temperatures in heating
56
POSSIBLE CAUSES
• No power supply
• The power switch is in "0" position
• Remote control batteries are flat
• The temperature set on the remote control is either
too high or too low (when using the
heating pump unit).
• The air filter has been blocked before the
respective cleaning LED was switched on.
• Indoor or outdoor air flow obstacles are present.
• The heating/cooling load has increased (for example
a door or a window was left open or equipment that
dissipates a large amount of heat was installed in the
same room);
• Both the internal units are running; the heating load is
greater than the power of each internal unit.
OPERATIONAL LIMITS
SOLUTIONS
• Check that mains power is present (by turning on
a light for instance).
• Check if the master switch is closed or if a fuse
is burnt (in this case replace the fuse). If there is
a magnetothermal circuit breaker instead of the
master switch, check if it tripped (if it did, rearm
it). Should the problem occur again, contact the
Service Center at once and do not attempt to run
the unit.
• Move the power switch to "1" position (fig. 50 ref.
A).
• If the batteries are flat, you will notice that no
messages are displayed and that the unit's
reception confirmation sound is missing when
you try to issue any command to it. In this case
replace the batteries.
• Check the temperature setting on the remote
control and correct it if need be.
• Check the air filter and clean it if necessary.
• Remove anything that might clog the air flows.
• Switch off one of the two internal units.
UNICO MASTER
mm 902x516x229
kg 40
Internal ambient temp.
DB 35°C - WB 24°C
DB 18°C
DB 27°C
-
WALL SPLIT
mm 760x253x190
kg 8
Outside ambient temp.
DB 43°C - WB 32°C
DB -10°C
DB 24°C - WB 18°C
DB -15°C