ACteon SATELEC i-SURGE Manuel D'utilisation page 9

Environment:
- Do not cover the device or obstruct the ventilation vents.
- Do not immerse the device in liquid, and do not use it outdoors.
- Do not tilt the device at an angle greater than 5°.
- Do not place the device near a heat source.
- Make sure that the cords are not in a traffic path.
- The device should be stored in its original packaging in a safe place.
- The device is not designed for use in the presence of anesthetic gases or any other flammable gas.
- Do not expose the device to water vapor, or splashes.
- The device is not designed to work near ionizing radiation.
- Do not insert metal objects into the device (risk of electric shock, short-circuit or emission of hazardous
substances).
Maintenance:
- Before and after each use, your device must be disinfected with products recommended by the manufacturer.
- Before each procedure, it is essential to make sure that the accessories to be used have been cleaned,
disinfected and sterilized.
- Do not use agents containing phenol, peracetic acid, peroxide and other agents that break up the oxygen.
- DO NOT (for any reason), lubricate the motor. After lubricating the handpiece, ensure that the lubricant does
not penetrate into the motor.
Accessories:
- The device can only accept accessories designed by BY DENTAL or distributed by SATELEC for the particular use
for which they are intended.
- Use of accessories from other manufacturers is a potential hazard for you or your patients.
Repair:
- Do not repair or modify the device without prior authorization from the manufacturer.
- In the case of a fault, contact the supplier of your device. Do not use unauthorized repairers, who might make
your device dangerous for you and your patients.
If you have any doubt, contact an approved dealer or our customer support department:
• www.acteongroup.com • E-mail: satelec@acteongroup.com.
9