Truma CP Plus Mode D'emploi page 32

Requirements for automatic climate control functioning as
expected:
1. The air conditioning system and heater cover the entire
area of the vehicle that is supposed to be automatically air
conditioned.
2. The room temperature sensor of the heater is the lead sen-
sor of automatic climate control and must therefore be in a
suitable location, i.e.
– in the area in which the required room temperature
should be reached.
– if possible, not influenced by outside temperature or
sunlight.
– not close to warm air ducts, cold air ducts or other sourc-
es of heat.
– warm or cold air from the air outlets must not flow
against the room temperature sensor. Particular attention
must be paid to this when adjusting the air throttles on
Aventa air conditioning systems.
– with good circulation and not on the vehicle ceiling.
Truma Partners are trained in the correct installation of auto-
matic climate control. You can find our Truma Partners at
www.truma.com.
4. °C / °F temperature display
Select the temperature display °C (Celsius) or °F (Fahrenheit).
Default setting: °C (Celsius).
32 EN
hot
5. Changing the background lighting
Change the background lighting of the Truma CP plus control
panel in 10 increments.
6. 12 h / 24 h mode
Display time in 12 h (a. m., p. m.) / 24 h mode.
Default setting: 24 h mode.
7. Changing the language
Select the desired language (German, English, French, Italian).
Default setting: English
8. Showing the version number
Display version number of heater, air conditioning system,
Truma CP plus control panel or iNetBox.
hot