Operating Instructions Intended Use; Safety Instructions; Important Notes - Truma CP Plus Mode D'emploi

Operating instructions
Intended use
The electronic Truma CP plus control panel
and monitor a Combi CP plus ready heater and / or a Truma air
conditioning system. The Truma CP plus
for operating connected appliances via the Truma App and
Truma iNet Box.
The Truma CP plus is intended for installation in caravans and
1
motor homes. Installation in boats is not permitted.

Safety instructions

– Operate the Truma CP plus control panel only if it is in a
technically perfect condition.
– Repairs must be carried out immediately. Only carry out
repairs yourself if the solution is described in the trouble-
shooting guide of these operating instructions.
– Do not carry out any repair work or modifications on the
Truma CP plus control panel!
– A defective Truma CP plus control panel may only be
repaired by the manufacturer or the manufacturer's service
department.
– Never use LP gas appliances when refuelling, in multi-
storey car parks, in garages or on ferries. Switch off the
Truma CP plus control panel to prevent the heater being
switched back on by the Truma App or the time switch
(see "Switching on/off").
And/or Truma CP plus CI-BUS for CI-BUS – not retrofittable.
1
22 EN

Important notes

– If the power supply to the system has been interrupted, the
– If a new or replacement appliance (heater, air condition-
is used to control
1
serves as an interface
1
– The ZUCB time switch can no longer be used when the
Air conditioning systems – joint use of IR remote control
and Truma CP plus control panel
– Even after connecting the Truma CP plus control panel, the
– Only the time switch of the Truma CP plus control panel
time / time switch must be reset.
ing system or Truma iNet Box) is connected to the bus sys-
tem, the procedure described in "Initial start-up" must be
repeated.
Combi CP plus ready heater is connected to the Truma
CP plus control panel.
IR remote control is available for controlling the air condi-
tioning system. The Truma CP plus control panel recognises
all settings that are made using the IR remote control on the
air conditioning system. The IR remote control only trans-
mits the settings that are shown in its display (no bidirec-
tional communication).
may be used to define the start and end time of a required
period.