Truma CP Plus Mode D'emploi page 29

– When air conditioning systems are being operated, the
time switch of the Truma CP plus control panel must
only be used to define the start and end time for a
required period of time.
– If the time switch has been activated (ON), the Deacti-
vate time switch menu is displayed first (OFF).
– Select icon in menu bar (4) with rotary push button.
– Change to the setting level by tapping on the rotary push
button.
Entering the start time
– Set the hours then the minutes with the rotary push button.
24 h mode
hot
Entering the end time
– Set the hours then the minutes with the rotary push button.
24 h mode
hot
12 h mode
hot
= a. m.
= p. m.
12 h mode
hot
= a. m.
= p. m.
If the start/end point was exceeded during entry, the
operating parameters are not taken into consideration
until the next start/end point has been reached. Until then,
the operating parameters that have been set outside the time
switch remain valid.
Setting the room temperature
For more information refer to "Changing the room tem-
perature" on page 25
– Select required room temperature with rotary push button.
– Tap the rotary push button to confirm the value.
Setting the hot water level
For more information refer to "Changing the hot water
level" on page 26
– Select required hot water level with rotary push button.
– Tap the rotary push button to confirm the value.
Selecting the energy type
For more information refer to "Selecting the energy
type" on page 26
– Select required energy type with rotary push button.
– Tap the rotary push button to confirm the value.
The select energy type menu is displayed if a heating
system with electric heating elements is connected.
EN 29