Güde GH 651 B Traduction Du Mode D'emploi D'origine page 21

Failure - Causes - Removal
Failure Cause
Jammed 1. Blunt knife
crushed
material
1. Jammed
Output crushing
drops mechanis
m
Engine 1. Empty
does not tank
start 2. No ignition
spark
3. Engine
with
excessive
consumpti
on
4. Blocked
knife
5. Lack of oil
protection
Removal
1. Sharpen or turn the knife
1. Switch off the appliance and
clean it
1. Fill up full tank; check whether
the carburettor contains fuel;
Check tank vent pipe and
perforate the hole in the tank
cover with a needle
2. Clean the ignition spark and
keep the distance of electrodes
at 0.6 –0.8 mm (pic. 19 a) or
use a new one;
Check the ignition cable;
Have the ignition checked at a
servicing centre
3. Screw out the sparking-plug,
clean and dry it;
Pull the starter cable several
times while the sparking-plug is
screwed out
4. Make sure that the crushing
mechanism was not blocked.
5. Please check carefully the oil
level and add motor oil again.
Place the unit in a horizontal
position.