Finish Cooking - ETNA KIV254KWIT Mode D'emploi

OPERATION
When the pan detection symbol flashes:
• you have not placed a pan on the correct cooking zone;
• the pan you're using is not suitable for induction cooking;
• the pan is too small or not properly centered on the cooking zone.
▷ No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn Off after 10 minutes if no suitable pan is placed on it.
▷
Then turn the control knobs to the zere '0' position
Caution!
Not all 4 zones can be set to setting 9 (or boost) at the same. The 4 zones can
be set to setting 7 at the same time. Another zone needs to be reduced first if a
higher setting is desired. You should then set the zones to a lower setting!

Finish cooking

1. Turn the cooking knob counterclockwise to zero (0) to turn Off the cooking zone.
After 15 seconds zere '0' will disappear from the display.
▷
Symbol H will appear in the display of the cooking zone which is too hot to touch. It will
disappear when the surface has cooled down to a safe temperature. It can also be used
as an energy saving function if you want to heat other pans, use the cooking zone that is
still hot.
EN 12