ETNA KIV254KWIT Mode D'emploi page 38

TROUBLESHOOTING
Symptom
The hob is not working and
nothing appears in the display.
A fuse blows as soon as the
hob is switched On.
Error code ER03.
Error code E3.
Error code E2.
Error code E6.
Other error code.
EN 18
Possible cause
There is no power supply due
to a defective cable or a faulty
connection.
The appliance is incorrectly
connected.
The control panel is dirty or
has water on it.
You held a key too long.
Unsuitable pan used.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Defective generator.
Solution
Check the fuses or the
electric switch (if there is
no plug).
Check the electrical
connections.
Clean the control panel.
Do not hold the button
too long.
Use a pan suitable for
induction cooking.
The appliance has been
switched Off because of
over heating.
Have your connection
changed.
Contact the service
department.