Indicator Light Functions; Ude Transmitter Indicator Lights - Jay Electronique UD Série Notice Technique D'installation Et D'utilisation

4.3- Product indicator lights function

4.3.1 UDE transmitter indicator lights

Error messages
Transmitter state
Red
(The transmitter stop
indicator light
palmswitch is unlocked)
Before or after
continuously OFF
"On/horn" button is
pressed
Before or after
continuously ON
"On/horn" button is
pressed
Before or after
flash in a alternative way
"On/horn" button is
pressed
Before "On/horn"
button is pressed
Before or after
"On/horn" button is
pressed
Before "On/horn"
button is pressed
Before "On/horn"
button is pressed
Before "On/horn"
button is pressed
Before "On/horn"
button is pressed
Battery pack charge level
Transmitter state
Red
(stop palmswitch button
indicator light
unlocked)
Before "On/horn"
OFF
button is pressed
Before "On/horn"
Flashes SLOW
button is pressed
Before "On/horn"
Flashes FAST
button is pressed
After "On/horn" button
OFF
is pressed
After "On/horn" button
Flashes FAST
is pressed
«LOW BATT level» = low battery (battery pack charge level lower than 10%), the battery pack must be reloaded.
UD - 319472K
LD
électronique
Green
indicator light
- Battery pack is discharged or disconnected
- Internal electronic failure
- Electronic key is not connected to
transmitter
- Bad connection of the electronic key
- Electronic key failure
- Internal electronic failure
- Access to the transmitter programming is
prohibited (the electronic key is locked)
- The transmitter identity code is different
3 flashes
from that contained in the electronic key
- Internal electronic failure
- The button configuration is different from
that contained in the electronic and the
physical configuration on the transmitter
4 flashes
- One or several function buttons are
defective
- Internal electronic failure
- Micro power cuts due to a bad battery pack
5 flashes
connection
- Internal electronic failure
6 flashes
- Internal electronic failure
7 flashes
- Internal electronic failure
8 flashes
- Internal electronic failure
Green
indicator light
ON
ON
ON
Flashes
Flashes
RED
indicator
light
Possible causes of failure
Function or corresponding message
Battery pack charge > 90%
90% > Battery pack charge > LOW BATT level
Battery pack charge < or = LOW BATT level
Radio transmission
Battery pack charge > LOW BATT level
Radio transmission
Battery pack charge < or = LOW BATT level
GREEN
indicator
light
Possible remedies
- Check battery pack load
or
- Contact the technical person in charge of
the installation
- Install electronic key on tranmitter before
powering up the transmitter
or
- Contact the technical person in charge of
the installation
- If the transmit frequency or "Dead man"
function duration must be changed, the
electronic key must be unlocked. Follow
procedure described in §3.5.1.
or
- Contact the technical person in charge of
the installation
- Reprogramming is required, see
procedure in §3.5.4.
or
- Contact the technical person in charge of
the installation
- Contact the technical person in charge of
the installation
- Check that battery pack is correctly
inserted in transmitter housing
or
- Contact the technical person in charge of
the installation
- Contact the technical person in charge of
the installation
- Contact the technical person in charge of
the installation
- Contact the technical person in charge of
the installation
DE EN FR
- 89 -