Déclaration De Conformité - Emerson FISHER RPE Notice Technique

Type RPE
DÉCLARATION DE CONFORMITÉ
Nous déclarons que les réchauffeurs électriques type RPE destinés à être mis sur le marché afin d'être utilisés en atmosphères
explosibles satisfont :
- aux dispositions de la directive 2014/34/UE
- aux normes : • EN 60079-0 : 2012
• EN 60079-1 : 2014
11 Description
Electric heater type RPE 180 985.
- The heater is to:
- Maintain a minimum temperature in the body of a regulator in 'zero flow' to assist start up.
- Maintain a minimum temperature in the control circuit of a pressure regulator.
- Options:
- Electric pilot heater (with heating pot).
- Regulator bottom electric heater (without heating pot).
The temperature regulation is carried out through a relay, by a probe HAGER type EK083 and
through a multi-range thermostat HAGER type EK 186 set to maximum 60°C (or equivalent).
The thermowell of the RPE is constantly bathing in the non-flammable gas. Around the RPE, an
explosive atmosphere may occur, when:
- Opening of a valve,
- Opening of a vent,
- Leakage at a sealed connection.
If the sensor is switched off, the heating elements are switched off.
The RPE can operate in the absence of gas circulation.
The thermowell is be mounted vertically.
Rating: 230 VAC – 280 W- 50/60 Hz
The heater is fitted with a ¾ NPT flameproof cable gland.
12 Certificate history and evaluation reports
Issue Date Associated report
0 06 Apr 2018 R11598A/00
Note: Drawings that describe the equipment or component are listed in the Annex.
13 Conditions of manufacture
The following conditions are required of the manufacturing process for compliance with the
certification.
13.1 Where the product incorporates certified parts or safety critical components the
manufacturer shall ensure that any changes to those parts or components do not affect
the compliance of the certified product that is the subject of this certificate.
14 Special Conditions for Safe Use (Conditions of Certification)
None.
This certificate shall only be copied
in its entirety and without change
www.CMLEx.com
6
CML 18ATEX11081
Issue 0
Notes
Issue of prime certificate
2 of 2
Version: 7.0 Approval: Approved
Figure 8. Certificats d'Examen
EU Type Examination Certificate
1 Equipment intended for use in Potentially Explosive Atmospheres Directive 2014/34/EU
2 Equipment Electric Heater Type RPE 180 985
3 Manufacturer FRANCEL SAS [Brand name FISHER]
4 Address Business Park
3 avenue Victor Hugo,
CS80125
28008 CHARTRES Cedex
France
5 The equipment is specified in the description of this certificate and the documents to which it
refers.
6 Certification Management Limited, Unit 1 Newport Business Park, New Port Road, Ellesmere
Port CH65 4LZ, UK, Notified Body Number 2503, in accordance with Article 17 of Directive
2014/34/EU of the European Parliament and of the Council, dated 26 February 2014, certifies
that this equipment has been found to comply with the Essential Health and Safety
Requirements relating to the design and construction of equipment intended for use in
potentially explosive atmospheres given in Annex II to the Directive.
The examination and test results are recorded in the confidential reports listed in Section 12.
7 If an 'X' suffix appears after the certificate number, it indicates that the equipment is subject to
conditions of safe use (affecting correct installation or safe use). These are specified in
Section 14.
8 This EU Type Examination certificate relates only to the design and construction of the
specified equipment or component. Further requirements of Directive 2014/34/EU Article 13
apply to the manufacture of the equipment or component and are separately certified.
9 Compliance with the Essential Health and Safety Requirements, with the exception of those
listed in the confidential report, has been demonstrated through compliance with the following
documents:
10 The equipment shall be marked with the following:
II 2 G
Ex db IIC T2 Gb
Ta = -20°C to +40°C
1 of 2
This certificate shall only be copied
in its entirety and without change
www.CMLEx.com
CML 18ATEX1081 Issue 0
H M Amos MIET
Technical Manager