Tunturi Pure 3.1 Mode D'emploi page 16

ERR3:
Lift motor error. Unplug the electrical
cord from the wall outlet and from the
treadmill, wait 1 minute and turn the
power switch on again. If treadmill
recovers to normal operation, you may
continue to use the treadmill Otherwise,
call the dealer for service.
TROUBLE SHOOTING
TREADMILL WILL NOT START
1. Not plugged in.
Plug into suitable outlet
2. Safety key not attached correctly.
Insert safety key
3. Treadmill circuit breaker tripped.
Reset circuit brear
4. On/Off switch not turned on.
Switch On/Off switch on
5. Auto Shut Down Time Out.
Unplug and replug power cord.
TREADMILL BELT SLIPPING
• Walking belt too loose
Check belt tension.
• Deck needs lubrication.
Check deck/ belt lubrication.
TREADMILL NOISY
• Loose hardware.
Tighten visible srews, nuts and bolds.
• Motor straining.
Belt tension to high.
• Clicking sound – roller knocking.
Adjust rear rollers – check the
tension.
INACCURATE PULSE RATE -HAND-
• Too much hand movement.
Stand on side rails to obtain accurate
pulse reading.
• Palms too wet.
Dry palms.
• Gripping handgrips too tight.
Grip using moderate pressure
• Wearing rings.
• Remove all rings
• Deck needs lubrication
Check deck lubrication
16
INACCURATE HEART RATE -STRAP-
• Chest strap pick-ups not moist.
Moisten pick-ups on chest strap.
• Electronical interference.
Keep at least six feet away from TV,
computer and fluorescent lights.
• Strap battery power low.
Replace strap battery.