Malfunctions; Error Codes - Tunturi Pure 3.1 Mode D'emploi

TO MOVE THE TREADMILL
Before moving the treadmill, be sure the
power cord is unplugged from the wall
and the treadmill. Fold up the running
deck until it is locked and push the
equipment on the transportation wheels.
NOTE!
Transport the treadmill with extreme
caution over uneven surfaces, for
example over a step. The treadmill
should never be transported upstairs
using the wheels over the steps, instead
it must be carried. We recommend
that you use a protective base when
transporting the equipment.
NOTE!
The running belt needs to be realigned
and centered after moving.
To prevent malfunctioning of the
treadmill, store it in a dry place with as
little temperature variation as possible,
protected against dust. Always unplug
the treadmill from the electrical outlet
when not in use.
O W N E R ' S M A N U A L

MALFUNCTIONS

NOTE!
Despite continuous quality control,
defects and malfunctions caused by
individual components may occur
in the equipment. In most cases it's
unnecessary to take the whole device
in for repair, as it's usually sufficient
to replace the defective part. Always
give the model, serial number of your
equipment and in case of malfunctions
also conditions of use, nature of
malfunction and any error code.
When you encounter unusual behavior
from the treadmill, simply turn the power
switch off, wait 1 minute and turn the
power switch on to reset the treadmill.
This should clear incidental errors and
ready the treadmill for normal operation
again. If after you have reset the
treadmill by turning the power switch off
and on again, and the treadmill is still not
operational, contact your local Tunturi
dealer for service.
If you require spare parts, always
give the model, serial number of your
equipment and the spare part number for
the part you need. The spare part list is
at the back of this man

ERROR CODES

The user interface will display
nformation about operational faults.
ERR1:
Speed sensor error. Unplug the electrical
cord from the wall outlet and from the
treadmill, wait 1 minute and turn the
power switch on again. If treadmill
recovers to normal operation, you may
continue to use the treadmill. Otherwise,
call the dealer for service.
GB
•
P U R E R U N 3 . 1
15