Tank Emptying; After Using The Machine; Machine Long Inactivity - Advance SC500 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TANK EMPTYING

An automatic float shut-off system (31) turns off the vacuum system when the recovery tank (33) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise, and the floor is not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the float is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the push-button (48),
then open the cover (34) and check that the float inside the grid (31) has gone down. Then close the cover (34)
and turn on the vacuum system by pressing the push-button (48).
When the recovery tank (33) is full, empty it according to the following procedure.
Recovery tank emptying
1.
Raise the brush deck by pressing the push-button (43).
2.
Lift the squeegee (29) with the pedal (8).
3.
Drive the machine to the appointed disposal area.
4.
Turn off the machine with the push-button (42) and remove the operator key (41).
5.
Empty the recovery tank (33) with the drain hose (12). Then, rinse the tank with clean water.
Washing water tank emptying
6.
Perform steps 1 to 4.
7.
Empty the washing water tank (21) using the level hose (13). Then, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1.
Remove the brush as shown in the relevant paragraph.
2.
Remove the operator key (41).
3.
Empty the tanks (21) and (33) as shown in the relevant paragraphs.
4.
Perform the daily maintenance procedures (see the Maintenance chapter).
5.
Store the machine in a clean and dry place, with the brush and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1.
Perform the procedures shown in After using the machine paragraph.
2.
Empty the EcoFlex™ system detergent tank (25) and clean the system with a draining cycle (see the procedure in
Maintenance chapter).
3.
Close the washing water valve (18-B).
4.
Disconnect the battery connector (9).
11/14
INSTRUCTIONS FOR USE
9099980000 - SC500
ENGLISH
17

Publicité

Table des Matières
loading

Table des Matières