Programming The Special Functions - Reely Supersonic Notice D'emploi

b) Programming the Special Functions
The speed controller is already pre-programmed with the most sensible pre-settings ex works.
If you use rechargeable LiPo batteries for operating the vehicle, you need to switch on the undervoltage
protection (recommended: 3.2 or 3.0 V/cell). With the undervoltage recognition deactivated, the LiPo battery
will suffer deep discharge and be destroyed.
If a NiMH drive battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo
batteries.
Programming is possible very easily via the setup button, two LEDs and the corresponding motor beeps.
The beeps are generated by a short start-up of the brushless motor.
The following setting functions and setting values are available:
Function
1 Drive function
2 Max. reverse speed
3 Brake force
4 Motor brake
5 Neutral range
6 Starting mode
7 Timing
8 Undervoltage protection 1x long +
9 Overtemperature
protection
10 Protection function for
LiPo
The grey values are the basic settings performed by the manufacturer at the time these operating instruc-
tions were drawn up.
Green LED
flashes....
1x short
(+ Beep)
1x short Forwards/
Brake
2x short 20%
3x short 25%
4x short 0%
5x short 3%
1x long + Very fast
1x short
1x long + 0°
2x short
switched off
3x short (NiMH)
1x long + 90 °C
4x short
1x long + Reduce
5x short power
Red LED flashes.... (+ Beep)
2x short 3x short
Forwards/ Forwards/
Reverse Brake/
Reverse
40% 60%
50% 75%
10% 20%
6% 9%
Fast Normal
5° 10°
2.8 V/cell 3.0 V/cell 3.2 V/cell 3.4 V/cell
100 °C off
Deactivate
motor
4x short 5x short 6x short
80% 100%
100%
40% 70% 100%
12%
Slow
15° 20°
51