Safety Tips; Product Description; Introduction; Pack Contents - Polar Refrigeration G608 Mode D'emploi

Plan de travail de comptoir de distribution / de préparation inox réfrigéré
Masquer les pouces Voir aussi pour G608:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
UK

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any
repairs if required. Do not remove any components or service panels on
this product.
Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT use the appliance outside.
DO NOT use this appliance to store medical supplies.
DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-
cream makers etc.)
DO NOT stand or support yourself on the base, drawers or doors.
DO NOT allow oil or fat to come into contact with the plastic
components or door seal. Clean immediately if contact occurs.
Bottles that contain a high percentage of alcohol must be sealed and
placed vertically in the refrigerator.
Always carry, store and handle the appliance in a vertical position and
move by holding the base of the appliance.
Always switch off and disconnect the power supply to the unit before
cleaning.
Keep all packaging away from children. Dispose of the packaging in
accordance with the regulations of local authorities.
If the power cord is damaged, it must be replaced by a POLAR agent or
a recommended qualified technician in order to avoid a hazard.

Product Description

G608 - POLAR 5 x ¼ Container Refrigerated Counter Top/Servery Prep
G609 - POLAR 7 x ¼ Container Refrigerated Counter Top/Servery Prep
G610 - POLAR 9 x ¼ Container Refrigerated Counter Top/Servery Prep
G611 - POLAR 10 x ¼ Container Refrigerated Counter Top/Servery Prep

Introduction

Please take a few moments to carefully read through this manual. Correct
maintenance and operation of this machine will provide the best possible
performance from your POLAR product.

Pack Contents

The following is included:
POLAR Refrigerator or Freezer
Top glass panel
Rear glass panel
Side glass panels x 2
Instruction manual
Collars x 6
POLAR prides itself on quality and service, ensuring that at the time of
packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR
dealer immediately.
1
Brackets x 7
Grub screws x 7
Screws x 12
Plugs x 14
Gastranorm adaptor bar
Adjustable feet x 4

Installation

Note: If the unit has not been stored or moved in an upright
position, let it stand upright for approximately 12 hours
before operation. If in doubt allow to stand.
Remove the appliance from the packaging. Make sure that all protective
1.
plastic film and coatings are thoroughly removed from all surfaces.
Maintain a distance of 20cm (7 inches) between the unit and walls or
2.
other objects for ventilation. Increase this distance if the obstacle is a
heat source.
Note: Before using the appliance for the first time, clean the
shelves and interior with soapy water.
Level the appliance by adjusting the screw feet.
3.

Fit Glass Panels

Screw the collars to the rim of the appliance.
1.
Note: Ensure the hole in the collar for the grub screw faces
inwards.
Slot the two side panels into the collars, with the holes in the glass at
2.
the top.
Note: Ensure the screw hole furthest from the edge of the
panel goes to the back of the appliance.
Screw a grub screw into each collar to secure the panels.
3.
Note: Ensure the soft end of the grub screw is the end making
contact with the glass.
Slot the rear panel into the collars, with the holes in the glass at the top.
4.
Screw a grub screw into each collar to secure the panel.
5.
Slot the plastic plugs into each of the holes.
6.
Screw the brackets to the inside of each pane using the bolt assemblies.
7.
Note: Ensure the short end of the bolt assembly is on the
outside of the panels.
Place the top panel onto the brackets, ensuring all holes line up.
8.
Insert the plugs and attach the top panel to the brackets with the bolt
9.
assemblies.
Bracket
Glass Panel
Bolt Assembly
Plug
Bolt Assembly

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:
Only store foodstuffs in the appliance when it has reached the correct
operating temperature.
Ensure gastronorm bays are full at all times, even if the gastronorms
are unused or empty. Empty bays will greatly reduce efficiency of the
appliance.
Do not obstruct the fans inside the appliance.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

G609G610G611

Table des Matières