Configuring The Device - Dräger X-zone 5000 Notice D'utilisation

Configuring the device

In this case, repeat the fresh air adjustment. If necessary

have the sensor changed by qualified personnel.
9.5.2 Performing a 1-button calibration
All the sensors which can be calibrated are included in the

1-button calibration.
In the case of the 1-button calibration, the sensitivity of all

sensors is set to the value of the test gas. When using the
test gas cylinder 68 11 130 = mixed gas with 50 ppm CO,
15 ppm H S, 2.5 Vol.-% CH
2
NOTICE
i i
If a mixed gas with another composition is used, the
specified concentration values in the X-am 5000/5600
must be changed to the target values of the mixed gas
used using the Dräger CC-Vision PC software.
1. Screw the valve onto the test gas cylinder.
2. Insert the X-am 5000/5600 in the device receptacle of the
X-zone 5000 and switch on (see chapter 3.1 on page 38).
3. Press the key and keep it pressed for 5 seconds to open
the calibration menu.
4. Enter the password (password on delivery = 001).
5. Select the 1-button calibration with the
for 1-button calibration »
6. Press the key to start the 1-button calibration.
OK
7. Connect the hose from the test gas cylinder to the X-
zone 5000.
8. Vent the test gas into a fume cupboard or into the open air.
The currently displayed measured values start to flash. The

flashing stops after a static measured value has been
reached.
The calibration is carried out automatically.

The displayed measured values change to the values

according to the gas supplied.
When the calibration has completed and the displayed
measured values have stabilized:
The display of the current gas concentration alternates with

the display » OK «.
9. Press the key to exit the calibration or wait for approx.
OK
5 seconds.
The X-am 5000/5600 changes to the measuring mode.

10. Disconnect the hose from the test gas cylinder from the X-
zone 5000.
If a fault has occurred during the 1-button calibration:
The fault message » X « appears and » - - « is displayed

for the respective sensor instead of the measured value.
In this case repeat the calibration.

If necessary, replace the sensor.

56
, 18 Vol.-% O .
4 2
key. The symbol
« flashes.
10 Configuring the device
IR
To individually configure a standard-configuration device,
connect the device to a PC.
Communication is carried out via a
(order no. 83 17 409)).
The Dräger CC-Vision PC software is used to perform the
configuration.
The following settings can be configured, among others:
Horn volume

Wireless function

Alarm frequencies

Alarm pattern

Alarm forwarding

Life signal (light pattern, horn volume)

Actions of the switch relay

NOTICE
i
i
Observe the documentation and online help of Dräger
CC Vision PC software.
02833112.eps
≥
USB DIRA III dongle
Dräger X-zone 5000