Télécharger Imprimer la page

BWT Multipur AP Instructions De Montage page 13

Publicité

Les langues disponibles

Les langues disponibles

> 400 mm
> 400 mm
> 400 mm
> 400 mm
> 400 mm
min. DN 50
min. DN 50
min. DN 50
min. DN 50
min. DN 50
Druck-Entlastungs-
schlauch einstecken
> 20 mm
> 20 mm
> 20 mm
> 20 mm
> 20 mm
> 1 m
> 1 m
> 1 m
> 1 m
> 1 m
Installation
Installation
Installation
Installation
Installation
Install the backwash filter horizontally in the cold
water line in the flow direction. (Observe the flow
direction arrow on the filter casing.)
Screw on the waste water connection, either for
pipe or for hose. Connect the drain line.
According to DIN EN 1717 the flushing water
According to DIN EN 1717 the flushing water
According to DIN EN 1717 the flushing water
According to DIN EN 1717 the flushing water
According to DIN EN 1717 the flushing water
hose must be secured at a distance of at least
hose must be secured at a distance of at least
hose must be secured at a distance of at least
hose must be secured at a distance of at least
hose must be secured at a distance of at least
20mm from the highest possible waste water
20mm from the highest possible waste water
20mm from the highest possible waste water
20mm from the highest possible waste water
20mm from the highest possible waste water
level (free discharge).
level (free discharge).
level (free discharge).
level (free discharge).
level (free discharge).
If desired, an external fault signal issued by a
potential-free contact can be connected to the
building automation system terminals.
Put in pressure relief hose from the solenoid valve
in the upper cutout of the drain connection
respectively in the sloping drill hole of the hose
liner.
A mains power outlet must be available in the
immediate vicinity (max. 1.2 m away).
Caution: Do not plug in the control unit at this
Caution: Do not plug in the control unit at this
Caution: Do not plug in the control unit at this
Caution: Do not plug in the control unit at this
Caution: Do not plug in the control unit at this
time.
time.
time.
time.
time.
Commissioning
Commissioning
Commissioning
Commissioning
Commissioning
Check that the filter and flushing water pipe have
been properly installed.
Slowly open the stop valves up- and downstream
min. DN 50
min. DN 50
min. DN 50
min. DN 50
min. DN 50
of the filter. Deaerate the pipework at the next bleed
point downstream of the filter, and drain water
briefly.
Check the seals of the installation and filter for
leaks.
3 3 3 3 3
Insert the cable plug connector of the transformer
into the socket (24V
Plug in transformer with plug (3 3 3 3 3 ). The first back-
washing cycle is performed automatically (during
backwashing the illuminated segments on the dis-
play turn).
The factory setting
24 V
24 V
24 V
24 V
24 V
24V).
24V
24V
24V
7 8
(7 days) appears.
GB GB
GB GB
GB
13
13
13
13
13

Publicité

loading