BWT Multipur AP Instructions De Montage page 11

Scope of supply Scope of supply Scope of supply
Scope of supply Scope of supply
2 2 2 2 2
Backw Bac Bac kwash filter Multipur AP kw kw ash filter Multipur AP ash filter Multipur AP ash filter Multipur AP, consisting of:
Bac Bac kw ash filter Multipur AP
1 1 1 1 1 filter
2 2 2 2 2 Electronic controller and backwashing device
3 3 3 3 3
with hydraulic drive, CIC connection
3 3 3 3 3 Transformer with plug
4 4 4 4 4 water outlet for pipe
water outlet for hose (dia. 20 mm)
5 5 5 5 5 manometer
5 5 5 5 5
- CIC connection cable
Accessories Accessories Accessories Accessories Accessories
- Interlock cable for parallel operation
2m with plug
Use Use
Use Use Use
The Multipur backwash filters are used for filtration
of drinking and industrial water to protect the water
1 1 1 1 1
mains and the connected fittings, equipment,
machinery, tanks, boilers and production facilities
from malfunction and corrosion damage caused
by foreign particles.
4 4 4 4 4
The filters can also be used for filtration of well,
process, boiler feed, cooling and air conditioning
water. In these cases In these cases, advice m In these cases In these cases In these cases
from a specialist. from a specialist. from a specialist. from a specialist. from a specialist.
The filters are unsuitable for oils, greases, sol-
vents, soaps and other lubricating media. Water-
soluble substances also cannot be separated off.
Function Function Function
Function Function
The untreated water flows through a stainless steel
filter element in the Multipur. Foreign particles >
100μm or > 200μm are thus retained. Depending
on their size and weight, these particles either fall
directly into the lower part of the filter housing, or
adhere to the filter element.
During backwashing, the seal at the rinsing water
outlet opens. The suction ring segments of the
backwashing element move from the bottom to
the top and back again over the entire filter surface
and thus clean the filter fabric by suction with clean
water at an extremely high flow rate.
Backwashing is carried out automatically at the
end of the set interval.
The pressure difference between the untreated
water inlet and the treated water outlet of the filter
is measured.
Order no. 10908
, advice m , advice m , advice must be obtained , advice m ust be obtained ust be obtained ust be obtained ust be obtained
GB GB GB GB
GB
11 11 11 11 11