Operation; Before Starting The Machine - Viper FANG 32T-EU Manuel D'utilisation

OPERATION

BEFORE STARTING THE MACHINE

WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates. Do not cover these
plates for any reason and immediately replace them if damaged.
BATTERY INSTALLATION
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly
installed or connected. The batteries must be installed by qualified personnel only.

Set the function electronic board and the battery charger (optional) according to the type of batteries used
(WET or GEL).

Check the batteries for damage before installation.

Disconnect the battery connector and the battery charger plug.

Handle the batteries with great care.

Install the battery terminal protection caps supplied with the machine.
The machine requires two 12 V batteries, connected according to the below diagram:
There are no batteries on the machine from factory, but customers can purchase batteries ( WET or GEL).

Buy appropriate batteries (see Technical Data paragraph).

For battery choice and installation, apply to qualified battery dealers.

Set the machine and the battery charger according to the type of batteries installed (WET or GEL) as shown in the
following para-grap
a) When batteries (WET or GEL) are already installed and ready to be used

Check that the batteries are connected to the machine with the charger plug.

Insert the ignition key (19) and turn it to "on".
If the green warning light (3) turns on, the batteries are ready to be used.
If the yellow or red warning light (3) turns on, the batteri es must be charged (see the procedure in Maintenance
chapter).
b) When batteries (WET) are installed on the machine, but without electrolyte
USER MANUAL
ENGLISH
17