Stopping The Machine; Machine Operation (Scrubbering And Drying) - Viper AS5160 Manuel Utilisateur

Masquer les pouces Voir aussi pour AS5160:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER MANUAL

Stopping the machine

9.
Stop the machine by using the handlebar (E) (only for machine without traction). Stop the machine by
releasing the switches (F) (only for machine with traction).
10. Stop the brushes and the vacuum system by pressing the switch (M). The vacuum system stops after a few
seconds.
11. Lift the brush/pad-holder deck (K) by pressing the pedal (L).
12. Lift the squeegee (I) with the lever (J).
13. Turn the ignition key (A) to "0".
14. Make sure that the machine cannot move independently.

MACHINE OPERATION (SCRUBBERING AND DRYING)

1.
Start the machine as shown in previous paragraphs.
2.
While keeping both hands on the handlebar press the safety switch (F, Figure8), then manoeuvre the machine
and start scrubbing/drying the floor.
3.
If necessary, stop the machine then adjust squeegee according to section "Adjusting balance of squeegee".
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Suggests to go near the walls with
the right side of the machine (A and B, Figure 9) as shown in the figure.
CAUTION!
To avoid any damage to the floor surface, turn off the brushes/pad-holders when the machine
stops in one place.
A
Figure 9
15
ENGLISH
B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

As5160t5000040150000406

Table des Matières